Preview: this page describes the next FireCAD release, planned for December 1, and the beta available now. For the current release, see Removing a Branch.
Command
| Command | Description |
|---|---|
ATREMOVE_BRANCH |
Put branch devices back on the trunk of their circuit |
Prerequisites
- A FireCAD project must be open
- The circuit must be the active circuit in the Circuits palette
- The active drawing must be part of the project
Overview
ATREMOVE_BRANCH takes devices off a branch and puts them back on the trunk of the same circuit. The devices stay connected. Only their branch marking is cleared: the branch number, any pinned branch number, and the device they branched from. Their addresses and load stay on the circuit, and their labels lose the branch number.
A branch is not a separate circuit, so nothing is left behind to clean up.
Steps
- Select the circuit in the Circuits palette
- Type
ATREMOVE_BRANCH - At "Select devices to remove from branch '[Circuit Name]':", select the branch devices
- Press Enter. The devices move back to the trunk
- Keep selecting to do more, or press Escape to finish
Tips
- To take a device off the circuit altogether, use Disconnecting Devices instead
- To move devices to a different branch, use
ATRELOCATE_BRANCH - You can also move devices between the trunk and a branch in the Project Circuits palette (right-click > Move to Trunk / Move to Branch). See Reordering Devices and Setting Branch Numbers
Related Commands
FireCAD is the industry-leading AutoCAD add-in for fire alarm system design — from circuit layout to wire routing to code-compliant reports.
Learn more and get started at getfirecad.com →
Inspect Point Integration — Fire alarm system device lists and bill of materials can be pushed directly from FireCAD into Inspect Point, eliminating manual data entry and ensuring every device is ready for inspection scheduling and ongoing asset management.
Learn more here →