Refreshing Block Definitions (Preview)

Preview: this page describes the next FireCAD release, planned for December 1, and the beta available now. For the current release, see Refreshing Block Definitions.

Command

Command Description
ATREFRESH_BLOCKS Reset every block definition in the drawing to the version in the project database

Ribbon: FireCAD > Validation > Reset Device Block Definitions

Prerequisites

  • A FireCAD project must be open

Before You Use It: There Is Usually a Better Option

ATREFRESH_BLOCKS is an older, all-or-nothing command from before FireCAD could override block definitions. If you only need to change one block, use the Block Editor (BEDIT) to override that block definition in this drawing instead. That changes only the block you edit and leaves every other block, every attribute position and the rotation grips alone. See Editing Project Block Definitions.

Use ATREFRESH_BLOCKS only as a last resort, for example when many block definitions in a drawing are damaged and you want them all back to the database version.

What It Does

  • Resets every block definition in the current drawing to the version stored in the project database
  • Resets every attribute to its default location and orientation, so manual label positions are lost
  • Stops the round rotation grip from working on blocks in the drawing. That grip rotates a symbol without rotating its attributes. After this command it still appears but does nothing, because the geometry it was attached to has been replaced. FireCAD writes the steps to repair it by hand to the command line when the command finishes
  • Refreshes device labels

Steps

  1. Type ATREFRESH_BLOCKS
  2. The Refresh Block Definitions warning explains the above. No is the default
  3. Click Yes only if you are sure. The block definitions are replaced and labels refresh
  4. Read the command line for the steps to repair the rotation grip, if you use it

Related Commands


FireCAD is the industry-leading AutoCAD add-in for fire alarm system design — from circuit layout to wire routing to code-compliant reports.
Learn more and get started at getfirecad.com →

Inspect Point Integration — Fire alarm system device lists and bill of materials can be pushed directly from FireCAD into Inspect Point, eliminating manual data entry and ensuring every device is ready for inspection scheduling and ongoing asset management.
Learn more here →

Was this article helpful?
0 out of 0 found this helpful