Deleting Orphaned Records (Preview)

Preview: this page describes the next FireCAD release, planned for December 1, and the beta available now. For the current release, see Deleting Orphaned Records.

Command

Command Description
ATDELETE_ORPHANS Remove project data left behind by devices and wires that were deleted from the drawing

Ribbon: FireCAD > Validation > Purge Deleted Entities And Circuits

Prerequisites

  • A FireCAD project must be open

Overview

When you erase a device or a wire path with AutoCAD's own commands, its project data (connections, circuits, addresses, properties) stays behind. ATDELETE_ORPHANS finds that leftover data and, after you confirm, removes it.

You always see what will be deleted first, and you can keep or restore anything on the list. This is the one command whose job is deletion: the wire path commands only remove their own segments.

Steps

  1. Click Purge Deleted Entities And Circuits on the Validation panel, or type ATDELETE_ORPHANS
  2. FireCAD checks the active drawing's devices and segments
  3. If it finds leftover data, the Delete Orphaned Data window lists every item
  4. Review the list:
    • Untick an item to keep it
    • Tick Restore to put an item back into the current drawing instead of deleting it
    • Select All / Select None tick or untick everything
  5. Click Delete to remove the ticked items, or Cancel to stop. Cancel reports Purge cancelled - nothing was deleted
  6. Device and wire path labels are updated

Before You Delete

  • Items marked (panel / assembly) or (originates circuits) are panels and other devices that circuits start from. Deleting one also deletes its circuits, device types and addressing, so every device on those circuits loses its connection
  • If an item is still in use and was only erased by mistake, use Restore instead of deleting it

When to Use

  • After erasing devices or wires with AutoCAD commands instead of FireCAD commands
  • When the Design Precheck or a report shows circuits or devices that are no longer in the drawing

Related Commands


FireCAD is the industry-leading AutoCAD add-in for fire alarm system design — from circuit layout to wire routing to code-compliant reports.
Learn more and get started at getfirecad.com →

Inspect Point Integration — Fire alarm system device lists and bill of materials can be pushed directly from FireCAD into Inspect Point, eliminating manual data entry and ensuring every device is ready for inspection scheduling and ongoing asset management.
Learn more here →

Was this article helpful?
0 out of 0 found this helpful