Creating a Branch (Preview)

Preview: this page describes the next FireCAD release, planned for December 1, and the beta available now. For the current release, see Creating a Branch.

Watch the Video

Open the video in a new tab (Creating a Branch, 40 seconds).

Command

Command Description
ATBRANCH Connect devices to the active circuit as a branch off a device already on it

Prerequisites

  • A FireCAD project must be open
  • An active circuit must be selected in the Circuits palette
  • The active drawing must be part of the project

Overview

A branch is a spur, such as a T-tap, off a device that is already on a circuit. It is not a separate circuit. The branch devices join the same circuit: they continue its addressing, their load counts toward it, and the riser draws them as a spur off the device you branched from.

Steps

  1. Select the circuit in the Circuits palette
  2. Click Branch in the Circuits palette, or type ATBRANCH
  3. At "Select a device on circuit '[Circuit Name]' to branch from:", pick the device the branch starts at. It must already be on the circuit
  4. At "Select devices to connect to '[Circuit Name]':", select the devices that make up the branch. These are devices that are not yet connected
  5. Press Enter
  6. The devices are connected as a branch. Their labels carry the branch number, for example P2•A1.1•68 for branch 1 of circuit A1

How Branch Numbers Are Given

  • Devices branched in one operation share a branch number
  • A new branch takes the lowest free number on that circuit. If branches 1 and 3 exist, the next branch is 2, so removing a branch does not leave a permanent gap
  • To keep a number fixed, pin it in the Project Circuits palette: right-click a branch device and choose Pin Branch Number. See Reordering Devices and Setting Branch Numbers

Example

A notification appliance circuit (NAC) with two T-taps:

Panel → NAC Circuit A1
         └── Strobe 1
              └── Branch A1.1: Strobe 2, Strobe 3
         └── Strobe 4
              └── Branch A1.2: Strobe 5, Strobe 6

Tips

  • The device you branch from is not changed
  • Branch devices continue the circuit's address sequence; the branch number appears in the label
  • Use ATRELOCATE_BRANCH to move devices from one branch to another
  • Use ATREMOVE_BRANCH to put branch devices back on the trunk of the circuit

Related Commands


FireCAD is the industry-leading AutoCAD add-in for fire alarm system design — from circuit layout to wire routing to code-compliant reports.
Learn more and get started at getfirecad.com →

Inspect Point Integration — Fire alarm system device lists and bill of materials can be pushed directly from FireCAD into Inspect Point, eliminating manual data entry and ensuring every device is ready for inspection scheduling and ongoing asset management.
Learn more here →

Was this article helpful?
0 out of 0 found this helpful