Preview: this page describes the next FireCAD release, planned for December 1, and the beta available now. For the current release, see Editing Assembly Properties.
Command
| Command | Description |
|---|---|
ATEDIT_ASSEMBLY |
Open the Assembly Editor for a placed panel or cabinet |
Ribbon: FireCAD > Edit > Assembly Editor
Prerequisites
- A FireCAD project must be open
Overview
An assembly in FireCAD is a panel, power supply or cabinet that holds cards and modules, for example a control panel with a main board and two loop cards. Each placed assembly has its own list of what is inside it, and the circuits it originates come from those cards.
The Assembly Editor is where you change that list for one placed assembly: add a loop card, remove an option card, or rename a card. If you pick a device that is not an assembly, the command says The selected device is not an assembly.
Steps
- Type
ATEDIT_ASSEMBLY, or click Assembly Editor on the ribbon - Select one placed panel or cabinet
- The Assembly Editor opens. Assembly Components lists the cards and modules in this assembly with their Part No, Manufacturer, Model, Description and Card Name
- To add a card, click Add Component and pick the part. Any part in the catalog can be added
- To remove one, select it and click Delete Selection. FireCAD asks you to confirm, because the card's circuits and every device connection on them are deleted with it
- Edit a Card Name to change the prefix its circuits carry in their labels. Device Name (Output Circuit Prefix) names the assembly itself
- Click Apply to save, or Cancel to close without changing anything
What Changes When You Apply
- A new card's circuits appear in the Circuits palette, ready to connect devices to
- Removing a card deletes the circuits it originated and the connections on them. The devices stay in the drawing, unconnected
- The card's current counts toward the panel's battery calculation and the Panel Summary
Tips
- Changes apply to this placed assembly only. Other copies of the same panel keep their own contents
- Check the panel's card loads afterwards in the Panel Summary report or the Design Precheck
- The Design Assistant can also add and remove cards when you ask it to
Related Commands
FireCAD is the industry-leading AutoCAD add-in for fire alarm system design — from circuit layout to wire routing to code-compliant reports.
Learn more and get started at getfirecad.com →
Inspect Point Integration — Fire alarm system device lists and bill of materials can be pushed directly from FireCAD into Inspect Point, eliminating manual data entry and ensuring every device is ready for inspection scheduling and ongoing asset management.
Learn more here →