Removing a Circuit Pair (Preview)

Preview: this page describes the next FireCAD release, planned for December 1, and the beta available now. For the current release, see Removing a Circuit Pair.

New in the next release

  • Circuit pairs are being retired. Use a segment label override instead: it changes only the text on the wire, so the circuit is not counted on wires it does not run on. For the return run of a circuit sharing a conduit, override the label with [fill] + SPARE or the text you need. See Overriding Segment Labels (Preview).
  • The command still works, and existing circuit pairs keep counting in wire labels and wire fill as before. It now prints "Circuit pairs are being retired. Use Override Segment Label (ATOVERRIDE_SEGMENT_LABEL) and [fill] + SPARE instead."
  • To turn a drawing's existing circuit pairs into label overrides, type ATCONVERT_CIRCUIT_PAIRS. Each label keeps reading as it does now, and the pairs are removed so wire fill and reports count only the circuits actually routed on the segment.
  • In the Project Circuits palette, the Add Circuit Pair and Remove Circuit Pair buttons are replaced by Override Segment Label.

Command

Command Description
ATREMOVE_CIRCUIT_PAIR Remove circuit pair associations from selected segments

Prerequisites

  • A FireCAD project must be open
  • An active circuit must be selected in the Circuits palette

Overview

The ATREMOVE_CIRCUIT_PAIR command takes the active circuit's wire back off the wirepath segments you select. It undoes Adding a Circuit Pair, which counts the active circuit's wire on segments that are not on its own path, such as the return run of a circuit sharing a conduit with its outgoing run. The wire labels and wire fill are updated afterwards.

Steps

  1. Select the active circuit in the Circuits palette
  2. Type ATREMOVE_CIRCUIT_PAIR in the AutoCAD command line
  3. Select the segment entities to remove pairing from
  4. Press Enter to confirm
  5. The active circuit's wire is removed from the selected segments, and the wire labels update

Related Commands


FireCAD is the industry-leading AutoCAD add-in for fire alarm system design — from circuit layout to wire routing to code-compliant reports.
Learn more and get started at getfirecad.com →

Inspect Point Integration — Fire alarm system device lists and bill of materials can be pushed directly from FireCAD into Inspect Point, eliminating manual data entry and ensuring every device is ready for inspection scheduling and ongoing asset management.
Learn more here →

Was this article helpful?
0 out of 0 found this helpful