Setting Elevations (Preview)

Preview: this page describes the next FireCAD release, planned for December 1, and the beta available now. For the current release, see Setting Elevations.

Command

Command Description
ATSET_ELEVATIONS Give selected devices a floor (elevation) number for the riser

Ribbon: FireCAD > Riser > Set Device Elevations

Prerequisites

  • A FireCAD project must be open

Overview

In FireCAD, a device's elevation is the floor or level it is on, as a whole number: 1 for the first floor, 2 for the second, and so on. The riser diagram uses it to put each device on the right floor. It is not a mounting height, and it is not used in voltage drop or wire length calculations.

Steps

  1. Type ATSET_ELEVATIONS, or click Set Device Elevations on the ribbon
  2. At "Select device(s) to set elevation:", select the devices on one floor
  3. At "Please type an elevation value:", type the floor number and press Enter
  4. Repeat for each floor

Using Elevations in the Riser

For the riser to use the elevations you set, open Riser Options and tick Apply Device Elevation & Column Assignments. You can name each floor (for example "LEVEL 1", "ROOF") with Elevation Names in Riser Options.

Tips

  • Select a whole floor plan's devices at once and give them one number
  • To fix a device's horizontal position in the riser as well, use Setting Riser Column

Related Commands


FireCAD is the industry-leading AutoCAD add-in for fire alarm system design — from circuit layout to wire routing to code-compliant reports.
Learn more and get started at getfirecad.com →

Inspect Point Integration — Fire alarm system device lists and bill of materials can be pushed directly from FireCAD into Inspect Point, eliminating manual data entry and ensuring every device is ready for inspection scheduling and ongoing asset management.
Learn more here →

Was this article helpful?
0 out of 0 found this helpful