Refreshing Reports (Preview)

Preview: this page describes the next FireCAD release, planned for December 1, and the beta available now. For the current release, see Refreshing Reports.

Overview

A report you place in the drawing is a snapshot of the design at that moment. When you change the design afterwards, the report goes out of date. FireCAD keeps track of this for you: every placed report remembers which report it is and what it was built from, and the Design Precheck tells you which ones no longer match.

Steps

  1. Open the Design Precheck (ATDESIGN_PRECHECK, or Design Precheck on the Design Assistant ribbon panel) and run it
  2. Out-of-date reports are listed under Report Validation
  3. Click Refresh Report on the report you want to update
  4. FireCAD removes the old table and places the regenerated report at the same location, so your sheet layout is unchanged

About ATREFRESH_REPORT

ATREFRESH_REPORT is the command the Refresh Report button runs. Typed on its own, it only says No pending report refresh and does nothing, because it needs a report picked in the Design Precheck first. Use the button.

When to Refresh

  • After moving devices between circuits, adding or removing devices, or changing device settings such as candela or tap watts
  • After changing circuit limits or settings in the Project Circuits Editor
  • Before issuing drawings: run the Design Precheck and refresh everything it lists

Related Articles


FireCAD is the industry-leading AutoCAD add-in for fire alarm system design — from circuit layout to wire routing to code-compliant reports.
Learn more and get started at getfirecad.com →

Inspect Point Integration — Fire alarm system device lists and bill of materials can be pushed directly from FireCAD into Inspect Point, eliminating manual data entry and ensuring every device is ready for inspection scheduling and ongoing asset management.
Learn more here →

Was this article helpful?
0 out of 0 found this helpful