How to connect riser circuits to control modules

Introduction

When using a control module it is necessary to select the correct riser input circuit when connecting AUX, NAC, or Audio input circuits to it. To set the input circuit type, use the Set Device Circuits command.

 

Set Riser Input Circuit

To set the riser input circuit type on a control module, select one (or multiple) control modules on the drawing. Then use the Set Device Circuits command-

 

mceclip1.png

 

mceclip2.png

 

Use the Input Circuit Selections dialog to choose the correct riser input circuit, then click 'Apply'. You will then be able to connect the riser circuit to the control module-

 

mceclip0.png

 

Was this article helpful?
0 out of 0 found this helpful